Trustbuilder MFA by inWebo
Trustbuilder MFA by inWebo
Breadcrumbs

VMware Horizon 7 Connection Server RADIUS configuration

1. Configure VMware Horizon 7 Connection Server

  1. Log in to the VMware View administrative interface.

  2. Navigate to View Configuration → Servers → Connection Servers in the administrative interface.

    image2017-9-18_11-44-27.png

  3. Select the connection server that you want to protect and click Edit.

    image2017-9-18_11-49-39.png

  4. Click on the Authentication tab.

  5. In the Advanced Authentication part, select RADIUS in the "2-factor authentication" drop-down list:

    image2017-9-18_11-54-57.png

  6. Enable "Use the same user name and password for RADIUS and Windows authentication".

  7. Select Create New Authenticator in the Authenticator drop-down list:

    image2017-9-18_11-57-52.png

  8. Add a New Authenticator: 
    image2017-9-18_12-20-59.png
    Fill the indication for your first inWebo RADIUS authentication server 

inWebo Radius server addresses :

(See RADIUS integration and redundancy for additional details and configuration)

Authentication type :PAP / Server Timeout 3 seconds (60s in Push Mode)

  1. Select Next and enable "Use a secondary server if primary is unavailable"

  2. Fill the indication for the secondary server:

    image2017-9-18_12-22-11.png

  3. For more details about redundancy you can check the following page: RADIUS integration and redundancy

2. Configure InWebo RADIUS connector

You can create your own InWebo account at InWebo Signup page. This will give you access to you InWebo Administration Console.

  • Once connected, go to Secure Sites tab > CONNECTORS section.

  • Select “Add a connector of type…”, and choose “RADIUS” or “RADIUS Push” :

  • The popup below will appear. Enter the External URL of to reach yourVMware Connection Server, along with the RADIUS secret you have defined earlier:

  • Click “Add”.